CAUTION:
t
Only the types of disc mentioned on the previous page can be played on this unit;
DVD-ROM, CD-ROM, CVD, VCD etc. cannot be played back.
t
A DVD-RW (video mode) can generally be played back, but not necessarily all
DVDs of this type: playback capability depends on the recording conditions.
t
A DVD-RW (VR mode) cannot be played back.
t
A DVD+R/+RW can generally be played back, but not necessarily all DVDs of this
type: playback capability depends on the recording conditions.
t
A DVD-R that has recorded movie data can generally be played back on this unit,
but not necessarily all DVDs of this type: playback capability depends on the
recording conditions.
t
A DVD-R without any recorded movie data cannot be played back.
Handling, storing and cleaning discs
t
Do not touch the door to the disc compartment while the disc is moving.
t
Never put anything except a 12cm DVD (or CD) into the disc slot. Foreign objects
can damage the unit.
t
Carefully wipe any fingerprints and dust from the signal surface of the disc (glossy
side) with a soft cloth. Wipe straight from the centre to the outside of the disc.
t
Never use chemical cleaning spray, liquids or solvents to clean discs. These
chemicals will permanently damage the plastic surface of the disc.
t
To remove a disc from its storage case, press down on the center of the case and
lift the disc out, holding it carefully by the edges.
t
Return any discs to their cases after use to protect them from dust and scratches.
t
To prevent warping the disc, do not expose it to direct sunlight, high humidity or
high temperatures for extended periods of time.
t
Do not apply paper labels or write anything on either side of the disc. Sharp
writing instruments, or the inks used in some felt-tip pens, may damage the
surfaces of the disc.
DVD set-up
Once you have made your initial settings, you can always operate the unit under
the same conditions. The settings will be retained in the memory until they are
changed, even if the power is turned off.
t
Press [DVD SETUP] to activate the DVD player OSD menu.
t
Press
/
to highlight and move between different sub-menus, then press to
enter the sub-menu.
t
Press / to move the highlight to the item you wish to select, then press to
enter.
t
Press / for adjustments.
t
Press [DVD SETUP] to exit the OSD menu.
Built-in DVD Player Operations
(Cont.)
39
