English
- 13 -
Using the Cable Holder
You can use the supplied cable holder as the
following:
Place the cable holder into the cable holder hole
•
located on the rear side of the TV as illustrated
above.
Place cables into the cable holder after all necessary
•
connections are made.
Remote Control Handset
Inserting Batteries
Remove the battery cover located on the back of
•
the handset by gently pulling backwards from the
indicated part.
Insert two
•
AAA/R3
or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
NOTE:
Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
Switching On/Off
To Switch the TV On
Connect the power cord to the 220-240V AC,
•
50 Hz outlet.
Switch the “
•
” button to position “|” so the TV
will switch to standby mode. Then the standby LED
lights up.
To switch on the TV from standby mode either:
•
Press the “
•
” button, P+ / P- or a numeric button
on the remote control.
Press the “
•
”, - or + button of the TV.
The TV will then switch on.
NOTE
: If you switch on your TV via
P
+/- buttons
on the remote control or +/- on the TV set, the
programme that you were watching last will be
reselected.
By either method the TV will switch on.
To Switch the TV Off
Switch the“
•
” button to position 2 as illustrated,
(
) so the TV will switch OFF.
To power down the TV completely, unplug
•
t h e p o w e r c o r d f r o m t h e m a i n s s o c k e t .
NOTE:
When the TV is switched to standby
mode, standby LED can blink to indicate that
features such as Standby Search, Over Air
Download or Timer is active.
[GB]_MB60_1825UK_IDTV_32843W_NICKEL16_10073015_50189428.indd 13
[GB]_MB60_1825UK_IDTV_32843W_NICKEL16_10073015_50189428.indd 13
31.05.2011 14:47:52
31.05.2011 14:47:52
