35
14. DETAIL
Various settings of contour correction.
1) DETAIL LEVEL : Setting of contour correction amount
The DETAIL level can be set to in a range of -128 to 127.The degree of
contour correction increases in the positive value setting, and it
decreases in the negative value setting. For factory setting, hold down
both the L and R buttons for approx. two seconds.
(Same as DETAIL LEVEL function of MAIN MENU.)
2) DETAIL FREQ
: Contours to be emphasized are biased in terms of
fineness.
•
LOW
: The lower band frequency is amplified.
•
MIDDLE : The standard amplification is performed.
•
HIGH : The high band frequency is amplified. Finer contour correction is carried out.
(Same as DETAIL FREQ. function of MAIN MENU.)
3) HIGH CHROMA :
High chroma detail on/off setting
The amount of DETAIL for the high chroma subject can be increased for the high chroma parts where
the detail is less effective.
•
OFF : High chroma detail correction will be off.
•
ON : Contours are enhanced for high chroma(strong color) subjects.
4) LEVEL DEPENDENT
: Level dependent setting
The noise for dark part of the image is prevented being emphasized in the detail correction.
The detail amount is reduced for image part below a constant level. Setting range is -128 to +127. Press
the R button to increase the standard level and effect, dark image becomes soft image. Press L button to
decrease the level and effect. (The entire image becomes blur in case of too large setting value.)
Press the L and R buttons simultaneously for about 2 seconds for factory setting.
DETAIL [ FILE1 ]
DETAIL LEVEL : 0
DETAIL FREQ. :MIDDLE
HIGH CHROMA :OFF
LEVEL DEPENDENT:-110
CRISP :-110
SOFT DETAIL W. :-118
SOFT DETAIL B. :-118
H/V BALANCE : 0
COLOR DETAIL :
INITILIZE :[PUSH L+R] 2SEC
