Hitachi H 60MC, Handling Instructions Manual

Page: 6 / 44

5
English
STANDARD ACCESSORIES
(1) Case ........................................................................... 1
(2) Bull Point (SDS-max shank) .................................... 1
(3) Side Handle
I type: bar type handle ................. 1
II type: D type handle ................... 1
Either type I or type II Side handle is attached.
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
䡬
Demolishing
䡬
Asphalt Cutting
䡬
Surface Roughing
䡬
Tamping
䡬
Groove digging and edging
䡬
Scooping Work
䡬
Hammer Grease A
500 g (in a can)
70 g (in a tube)
30 g (in a tube)
Optional accessories are subject to change without
notice.
APPLICATIONS
Demolishing concrete, chipping off concrete, grooving,
bar cutting, and driving piles.
Application examples:
Installation of piping and wiring, sanitary facility
installation, machinery installation, water supply and
drainage work, interior jobs, harbor facilities and other
civil engineering work.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
SPECIFICATIONS
Voltage (by areas)* (110V, 120V, 127V, 220V, 230V, 240V)
Power Input 1250 W*
Full-load Impact Rate 1600 min -1
Weight (without cord, side handle) 10.2 kg
*Be sure to check the nameplate on product as it is subject to change by areas.
(1) Bushing Tool
(2) Shank
(1) Bull Point
Overall Length: 280, 400 mm
(1) Scoop
(1) Cutter
(1) Rammer (2) Shank
(1) Cold chisel
Overall length: 280, 400 mm
DEMOLITION HAMMER SAFETY WARNINGS
1. Wear ear protectors
Exposure to noise can cause hearing loss.
2. Use auxiliary handle(s), if supplied with the tool.
Loss of control can cause personal injury.
3. Hold power tool by insulated gripping surfaces, when
performing an operation where the cutting accessory
may contact hidden wiring or its own cord.
Cutting accessory contacting a "live" wire may make
exposed metal parts of the power tool "live" and
could give the operator an electric shock.
4. Do not touch the bit during or immediately after
operation. The bit becomes very hot during operation
and could cause serious burns.
5. Before starting to break, chip or drill into a wall,
floor or ceiling, thoroughly confirm that such items
as electric cables or conduits are not buried inside.
6. Wear a mask when turning your head upward.
7. Properly set the bit holder
8. At the start of work, confirm screw tightening.
9. When working at a highly elevated location, pay
attention to articles and persons below.
10. Wear protective shoes to protect your feet.
01Eng_H60MC_WE 3/7/12, 8:24 AM 5