-4-
Fig. 5
Fig. 6
Put the parts together in the reverse order of disassembly, with the precautions given below.
(1) Apply machine oil to Felt Packing (B)
[19]
then mount it to the Packing Gland
[22]
to increase the dust
resistance.
(2) Generously lubricate the teeth of the Gear and Pinion Set
[29]
with grease. Rub grease onto the teeth
with your fingers so that the grease reaches each tooth bottom. Note that under-lubricated Gear and
Pinion Set
[29]
may wear at a faster rate.
(3) When replacing the Armature
[12]
and the Ball Bearing 6000VV
[32]
on the commutator side, press
inward on the Dust Seal
[31]
while taking care of its direction until the end face of the Dust Seal
[31]
hits against the butting surface of the Armature
[12]
and make sure that the Dust Seal
[31]
cannot turn
freely as shown in Fig. 6. The Dust Seal
[31]
is an important element for improved dust protection of
the Ball Bearing 6000VV
[32]
. Be sure to use a new one at every disassembly work of the Ball Bearing
6000VV
[32]
.
(4) Apply Three Bond TB 1406 screw locking agent to the following screws. (See Fig. 5.)
• Two Machine Screws M5 x 10
[16]
which fix Bearing Cover (B)
[17]
in place
• Four Bolts M5 x 16
[23]
which fix the Packing Gland
[22]
in place
Reassembly
[29]
[16]
[23]
[22]
[17]
Pinion
Gear
[12]
[32]
[31]
[18]
[19]
[20]
[21]
