-11-
Socket
Small flat-blade
screwdriver
Guide Sleeve (A)
[6]
Retaining Ring
[3]
Washer (D)
[4]
(2) Removal of Guide Sleeve (A)
[6]
Remove the Retaining Ring
[3]
, Washer (D)
[4]
, Guide Spring
[5]
and Guide Sleeve (A)
[6]
in order by
following the procedure shown in Fig. 1-1 to 1-4.
Then slowly raise the other side of the retaining ring with the small flat-blade screwdriver until it is free.
Avoid quickly raising the retainer ring or it may fly out forcefully.
Fig.1-1
Hold the body and adjust the gap of the Retaining Ring
[3]
to the groove of socket, then insert a small flat-blade
screwdriver into the groove at an angle.
Fig.1-2
Press down Washer (D)
[4]
with the small flat-blade
screwdriver.
Fig. 1-3
Slide the small flat-blade screwdriver under one side of
the gap of the Retaining Ring
[3]
.
Fig. 1-4
Slowly raise the retaining ring using the end face of
Guide Sleeve (A)
[6]
as a fulcrum.
(3) Disassembly of the clutch unit
Remove the Clutch Dial
[7]
after removal of Guide Sleeve (A)
[6]
. Turn the Nut
[8]
counterclockwise and
remove it from the Gear Case
[12]
. Remove the Spring
[9]
and Washer (D)
[10]
from the Gear Case
[12]
.
NOTE: Do not remove the Gear Case [12].
5. Disassembly of the power supply unit
The internal wires of the Switch (W/Lock)
[41]
and Terminal
[46]
are soldered to the Printed Circuit Board
[45]
. Unsolder and remove the parts.
NOTE: Do not remove the Printed Circuit Board [45].
