
-5-
HOW TO CLEAR A BLOCKAGE
If your cleaner is used when the dust bag is full or any blockages are sucked in by
accident,the air ducts may become clogged. If this occurs, remove the blockages
or obstructions from the air ducts as follows.
CAUTION: Be sure to disconnect the plug from the electrical outlet.
*
DUCT HOSE
1. Change the dust bag. (See page 6)
2. Turn the cleaner over. Release the handle to the middle position. Remove the
3 screws from the belt cover
.
3. Remove the belt cover, and take off the hose supporter
to check the duct
hose .
4. To remove the duct hose, twist it clockwise.
*
FLEXIBLE HOSE
1. To disconnect flexible hose from the suction
inlet, press two joints
firmly.
2. After removing blockage from the flexible hose
and/or suction inlet, replace the hose and
connect securely.
*
JOINT PIPE
Blockages may be cleared by separating the
curved joint pipe
from the hose. To separate the
joint pipe, depress the two claws
which are
located in the holes
on both sides of joint pipe
and pull apart.
To re-connect push hose back into joint pipe and
twist until two claws
locate with holes
.
Fig. 16
Fig. 17
18
19 21
20
5. After removing blockage from the duct hose, reinstall the duct hose by twisting
counterclockwise, and replace the hose supporter on the case securely.
6. Place the four projections of the belt cover to the windows
provided on the
front end of case and replace the belt cover, and re-fasten the screws securely.
14
15
16
17
18
19
20
21
20
21
14
16
15
Fig. 14
17
Fig. 15