6
B. Dust Cover Ass’y [88] (Model CM 9SR) [92] (Model CM 9UBY]
The
[Bold]
numbers and the circled numbers in the descriptions below correspond to the item numbers in
the Parts List and the exploded assembly diagram of the Model CM 9SR. (The dust cover ass'y is common
to that of the Model CM 9UBY.)
(1) Loosen the Wing Nut M6
[48]
and lower the
Base
[68]
in “G” direction.
(2) Loosen the two Knob Nuts
[37]
and remove
Cover (B)
[35]
.
(3) Loosen the two Wheel Nuts M14 x 2
[59]
using the attached Wrench
[502]
and remove
the diamond wheel and Wheel Washer (A)
[58]
together from the
Spindle
[13]
.
(4) Open the Lever
[52]
and loosen the
Bolt
M8 x 22
[53]
to remove the
Dust Cover Ass’y
[88]
(Wheel Guard Ass’y
[56]
) from the
Packing Gland
[15]
.
(5) Loosen the two Wing Nuts M6
[48]
and
remove the two Bolts (Square) M6 x 57
[41]
and the Sleeve
[47]
from the Wheel Guard
Ass’y
[56]
.
(6) Remove the Hose Band
[33]
from the Dust
Duct
[34]
to remove the Adapter
[38]
.
(7) Loosen the U-Nut (B) M8
[93]
. Remove Bolt
(A)
[57]
from the Holder
[61]
to remove the
Wheel Guard Ass’y
[56]
,
Cover (A)
[60]
and
Dust Duct
[34]
.
(8) Remove the eight Retaining Rings (E-Type)
for D7 Shaft
[64]
to remove the two Roller
Shafts
[66]
from the Base
[68]
. At this time,
remove the four Rollers
[65]
,
Holder
[61]
and
Pocket Guide
[63]
together.
Reassembly can be accomplished by following the disassembly procedure in reverse.
Refer to each TECHNICAL DATA AND SERVICE MANUAL of the base Models G 13SB3 (List No. E271),
G 23SR (List No. E273) and G 23UBY (List No. E282) for precautions in disassembly and reassembly,
lubrication points and types and amounts of lubricant, tightening torque, and wiring diagram.
Reassembly
Diamond wheel
G
