Hitachi CE50-10, Instruction Manual

Page: 134 / 194

- Hagiwara Solutions product
<Options>
No options need to be specified. Any specified options are ignored.
<Diagnosis>
For the exit code,
0
is returned if the status is normal and
1
is returned if an error is detected. Table 5‒35: List of
disklchk command error messages below shows error messages that are output when an error is detected.
Table 5‒35: List of disklchk command error messages
No. Error message Description
1 disklchk: No supported disk. An unsupported SSD is installed.
2 disklchk: Failed to get SMART. An attempt to acquire SMART information failed.
5.18.9 fsconfchk
<Name>
fsconfchk
- Check mount definitions.
<Format>
fsconfchk [confname]
<Description>
fsconfchk
is a check command for mount definition files in the user area. This command checks for syntax
errors in mount definitions, but it does not check the consistency with partition information in the disk.
<Options>
If no option is specified, the command checks the contents of the /hitachi/etc/fsconf file.
• [confname]
Specify the path of the file you want to check. If the file name is specified by the option, the command checks
the contents of that file.
<Diagnosis>
For the exit code,
0
is returned if the status is normal and
1
is returned if an error is detected. Table 5‒36: List of
fsconfchk command error messages below shows error messages that are output when an error is detected.
Table 5‒36: List of fsconfchk command error messages
No. Error message Description Action
1 Device not found.
(line=
X
)
The device file specified for
device
on line X is not found.
1. Check whether the device name is
correct.
2. Check whether the partition
specified for
device
has been
created.
2
Illegal paramater.
(line=
X
, param=
P
)
The parameter P on line X is invalid. Check whether the parameter is
correct.
3 XXXX
file not found.
The file specified for XXXX is not
found.
Check whether the file name is
correct.
4
Invalid definition.
(line=
X
)
The number of parameters on line X is
invalid.
Check whether the parameters are
correct.
5
/dev/
XXXX
is
redefined. (line=
Y
)
Device XXXX is specified more than
once. The second one is specified on
line
Y .
Delete the duplicated line.
5. Configuring Software Environment
118