Hitachi CDH-LE32FD14, Service Manual

Page: 50 / 98

‐ 50 ‐
5M67B Factory Adjust Menu
(V0.0)
1. Description
Enter factory mode:
Open source menu, and then press digital button “3”,”1”,”9”,”5” in turns to enter the
factory menu. Press
↑
and
↓
button to choose the item, press OK button enter the
submenu, press MENU to ruturn to upper menu, press
←
and
→
button to adjust the value.
Leave factory mode
：
Press menu button to back to upper menu until leave factory mode or press exit button.
Software information
：
Enter factory mode, you can get the software information from the bottom of the menu.
Panel information:
Enter factory mode, enter “Panel Control” item, you can get the panel information from the
bottom of this menu.
Aging mode:
Enter factory mode, enter “System Setting” item, press
→
botton to open the aging
mode.
ADC adjust:
YPBPR source ADC:
Switch to COMPONENT source, input 100% color bar pattern, enter factory, select
“AUTO ADC” item in the “ADC ADJUST” menu, press
→
button to begin auto adjust. When
it is finish, it will show “SUCCESS” or “FAILE”. If “FAILE” is showed, you need to try again.
NOTE: YPBPR ADC need to do twice by use 576P and 720P signal separate.