Hitachi CC9SM, Service Manual

Page: 51 / 92

45
CP-S245(CC9SMN)/CP-X255
/ED-X8255
(CC9XMN)
/PJ656(CC9XM)
c. Attach the Lamp door.
2. Replacing the power units.
Remove the 4 screws to take off the ballast bracket.
NOTE : One of screws is behind the Front Shade.
Remove the
Front Shade
Lamp door
Power supply bracket
CAUTION
The ballast bracket holding the bal-
last power unit is installed under-
neath the power supply bracket.
Be careful not to injure your fin-
gers or hand by the edges of the
ballast bracket during mainte-
nance around the power units.
CAUTION
W h e n r e - a s s e m b l i n g ,
tighten this screw at the
torque of 0.49±0.1N·m so
t h a t t h e b o t t o m c a s e
does not strain.
Ballast bracket
CAUTION
Tighten this screw using a manual screwdriver.