Before installing your TV please read the following important notes:
If you intend placing this TV into a cabinet or a wall alcove, please ensure there is at least a 100mm (10cm) gap to the
sides, rear and top of the Television. This is to allow for adequate ventilation during TV operation.
Don’t allow soft furnishings such as curtains to be draped over the TV whilst in operation.
Never place the TV on to a carpet during normal operation - this could obstruct ventilation slots on the base of the TV.
Always place the TV on a flat surface , or if supplied, the stand accessory.
Failure to observe the above guidelines could result in serious overheating of your TV, or in extreme cases, even fire.
TV Installation
TV Installation
*A scart lead should be fitted between your TV and VCR to enhance your picture and sound quality. Scart leads are
essential if you have a stereo TV and VCR and wish to obtain stereo sound from your equipment. These leads can be
purchased from your Hitachi dealer or any good ‘High Street’ electrical retailer.
Step 1.
Connecting your TV to the mains socket.
(Please read the Safety Notes on page 3 with reference
to unattended operation).
Insert Plug and
Switch on
5
5
Step 2.
TV only installation.
Step 3.
Installation via a VCR.
Aerial (RF) Lead
Aerial (RF) Socket
Aerial (RF) Lead
Aerial (RF) Socket VCR
Aerial (RF) Socket TV
(RF) connecter lead VCR to TV
OUT
*Optional Scart Lead TV
to VCR
wall socket
wall socket
