18
English
PRACTICAL APPLICATIONS
WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the
tool is being operated.
*
Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 22).
Line
Warning Sign
Line
Warning Sign
Fig. 22
1. Switch operation
The trigger switch lock-o
ff
button is designed to prevent inadvertent operation
of the power tool. To operate the power tool, it is necessary to
fi
rst fully insert
the lock-o
ff
button into the hole on the handle as shown in Fig. 23.
The trigger switch will not operate unless the lock-o
ff
button has been pushed
in.
When the trigger switch is released, the power goes o
ff
and the lock-o
ff
button
automatically returns to its initial position, locking the trigger switch.
WARNING:
Always remove the lock-o
ff
button from the handle when the power tool is not in
use. This will ensure that the power tool cannot be turned on accidentally or by
someone (especially a child) who is not quali
fi
ed to use the power tool. If the lock-
o
ff
button is left in the handle, serious personal injury can result. Since the lock-o
ff
button
fi
ts rather tightly, it may be necessary to turn it to the left and right during
mounting and removing.
2. Using the Vise Assembly (Standard accessory)
The vise assembly can be mounted on either the left fence (Fence (B))
or the right fence (Fence (A)), and can be raised or lowered according
to the height of the workpiece.
To raise or lower the vise assembly,
fi
rst loosen the 6mm knob bolt. As
shown in Fig. 24, the vise shaft has three locking grooves into which
the tip of the 6mm wing bolt is designed to
fi
t in order to lock the screw
holder in the desired position.
To ensure that the tip of the 6mm wing bolt is properly aligned with the
desired locking groove on the vise shaft, simply align the upper surface
of the fence to either of three v-grooves on the vise shaft surface or to
the lower surface of the screw holder.
Therefore, the vise assembly can be attached in either of three
positions to ensure proper height adjustment.
After adjusting the height,
fi
rmly tighten the 6mm wing bolt; then turn
the upper knob, as necessary, to securely attach the workpiece in
position.
CAUTION:
Always con
fi
rm that the motor head (see Fig. 1) does not contact the vise assembly
when it is lowered for cutting. If there is any danger that it may do so, loosen the
8mm knob bolt slightly and move the vise assembly to a position where it will not
contact the saw blade.
Fig. 23
Handle
Trigger
Switch
Lock-o
ff
Button
Hole
Fig. 24
Screw Holder
Knob
Work piece
Vise
Plate
Groove
6mm
Knob Bolt
Fence
6mm Knob Bolt
V-Groove
0000Book̲C10FSH.indb 18
0000Book̲C10FSH.indb 18
2015/08/10 15:19:17
2015/08/10 15:19:17
