18
English
Marking
(pre-marked)
(2) Then, turn the adjuster and shift the laser line. (If you turn the
adjuster clockwise, the laser line will shift to the right and if
you turn it counterclockwise, the laser line will shift to the left.)
When you work with the ink line aligned with the left side of
the saw blade, align the laser line with the left end of the groove.
(Fig. 22) When you align it with the right side of the saw blade,
align the laser line with the right side of the groove.
(3) After adjusting the position of the laser line, draw a right-angle
ink line on the workpiece and align the ink line with the laser
line. When aligning the ink line, slide the workpiece little by
little and secure it by vise at a position where the laser line
overlaps with the ink line. Work on the grooving again and check
the position of the laser line. If you wish to change the laser
line's position, make adjustments again following the steps from
(1) to (3).
Fig. 23
NOTE:
Check and make sure on a periodic basis if the position of the laser line is in order. As regards
the checking method, draw a right-angle ink line on the workpiece with the height of about
25/32" (20mm) and the width of 5-29/32"(150mm), and check that the laser line is in line with
the ink line [The deviation between the ink line and the laser line should be less than the ink
line width (0.5mm)]. (Fig. 23)
PRACTICAL APPLICATIONS
WARNING:
* To avoid personal injury, never remove or place a workpiece on the table while the tool
is being operated.
* Never place your limbs inside of the line next to warning sign while the tool is being
operated. This may cause hazardous conditions (see Fig. 24).
Fig. 24
1. Switch operation
The trigger switch lock-off button is designed to prevent inadvertent
operation of the power tool. To operate the power tool, it is
necessary to first fully insert the lock-off button into the hole on
the handle as shown in Fig. 25.
The trigger switch will not operate unless the lock-off button has
been pushed in.
When the trigger switch is released, the power goes off and the
lock-off button automatically returns to its initial position, locking
the trigger switch.
Fig. 25
Handle
Trigger
Switch
Lock-off Button
Hole
Warning Sign
Line
Warning Sign
Line
Vise Assembly
Turn
Move
Laser Line
Groove Adjuster
Laser Line
Fig. 22
