Hitachi AX-M910, Instruction Manual

Page: 22 / 26

- 21 -
You can store the well tuned station by pressing the
PROGRAM
button. (You can preset up to 16 FM
stations.)
z
Tune in the desired station, then press the
PROGRAM
button.
z
Use the H button or G button on the remote control once by once to select the preset number. (You
can also press the key “
H
,
G
” on the panel of unit.)
z
Press the
PROGRAM
button to store the station. After 1 second, the VFD returns to the broadcast
frequency display.
Note: If the system is unplugged or if a power failure occurs, the preset stations will remain stored in
the memory.
Press the
H
,
G
button once by once to select preset number after presetting station and when in
storing the stations. Its band and frequency are displayed on the VFD.
(You can also press the key “
H
,
G
” on the panel of unit.)
Press the
MODE
button to select the Stereo or MONO reception to receive the FM radio channel, it can get
the best effect. “ST” indicator will be shown on display for stereo reception.
RDS (Radio Data System) Reception
Many FM stations are broadcasting added data compatible with RDS. This radio set offers
convenient information using such data.
Š Š
Š Š Š
PS (Program Service Name)
When an RDS station is received, the RDS indicator lights and automatically displays the name of
that station instead of the frequency. When
OSD/RDS
button on the remote control is pressed during
PS display, the CT is displayed for 3 seconds, then PS display returns.
Š Š Š Š Š
PTY (Program Type)
Program type identification signal. (Example: News, Rock, Classical music.)
Š Š Š Š Š CT (Clock Time System)
The CT system may not properly operate in areas where RDS CT service is not available. Once CT
service is received, the CT system keeps operating. “RDS CLOCK” is displayed in areas where no
CT services are available.
Š Š
Š Š
Š Changing Display
During PS display, press the RDS display button (RDS) on the remote control repeatedly to select the
CT, PTY or Frequency. They will be displayed for 3 seconds, then the PS display returns.
Clock/Timer Functions
Setting the Clock
The built-in clock shows the time in the display.
-
In standby mode, press the
CLOCK
button, hour indicator will blink.
- Set the hour with the
VOL-
button or
VOL+
button.
- Press the
CLOCK
button, minute indicator will blink.
- Set the minute with the
VOL-
button or
VOL+
button.
- Press the
CLOCK
button, the built-in clock starts operating.
Note:
* You can only set the daily timer in standby mode.
* The operating time of every step shouldn’t be longer than 10 seconds or it will return to the original
display.
* If there is a power failure or the power system is turned off, the clock will lose its setting.