Hardware components
4–21
Hitachi AMS 2100/2300 Storage System Hardware Guide
LOC LED
The (orange) LOC (locate) LED indicates various controller conditions
depending on the speed and number of blinks, as described in
to solve indicated problems and/or call
Hitachi Data Systems Technical Support for help.
Table 4-16: LOC LED
Number
of blinks
Description
6 (slow)
Voltage on the control unit is abnormal. (Reset of the control unit is not
canceled)
1 (fast)
1
1.When blinking fast, the LED is on for 400ms and off for 200 ms for each fast
blink. After the number of fast blinks has completed, the LED ID off for one
second.
SRAM error.
2 (fast)
ENC hard error.
3 (fast)
Firmware error in flash memory.
4 (fast)
ENC firmware has detected a CUDG error in the ENC unit.
ON
Boot section error in the ENC firmware, a RAM error, or ENC hard
configuration error.
Summary of Contents for AMS 2100
