Hitachi AMS 2100, Hardware Manual

Page: 211 / 306

Configuration
7–29
Hitachi AMS 2100/2300 Storage System Hardware Guide
1. Select the method of setting the date and time and enter the appropriate
date and time for your location.
• Select
Set Automatically to use the date and time settings from
the server on which Navigator 2 is installed.
• Select Set Manually, and enter the date and time for your
location.
• Select Keep current setting to use the date and time that is
currently set in the array clock.
2. Click Next> to continue to the confirmation pages.
Confirm
The Confirm dialog box is divided into six pages, one for each of the settings
dialog boxes described above. View the settings on each page and click
Next> to view the next page or <Back to go back to the desired screen to
change settings.
After you have reviewed all of the confirmation pages, click Confirm on the
page to save the settings. Depending on the communication speed and
network activity, it make take a several seconds to save the settings. When
the settings are saved, the wizard displays the Finish screen.
Finish
This screen contains a message that the wizard has successfully completed
the setup. Click OK to acknowledge the message and close the wizard.
Restoring the management console
Completed the following steps to restore the management console network
environment:
1. Reset the IP address to its original setting. See the section titled
Installing Storage Navigator Modular 2 on page 5-57 .
2. Reconnect the LAN cable to the management port on the array.
NOTE: You can also set Time Zone and NTP (Network Time Protocol) after
finishing the Initial Setup Wizard. Both the NTP and the Edit Date and Time
dialog boxes can be used to set the time. The setting made last from either
dialog box is the setting that will used.
NOTE: You cannot change settings on the confirmation screens. You must
go back to the original screens to make changes.