45
GU
ID
E
A/V
N
ET
HOW TO USE THE REMOTE
TO CONTROL CABLE BOX FUNCTIONS
Operating the precoded function for your cable box.
This remote is designed to operate different types of cable boxes. You must first program the remote to match the remote system of
your cable box (refer to pages 51-52 for pre-codes).
1.
Turn ON your cable box.
2.
Aim the remote control at the front of your cable box.
3.
To switch to Cable (CBL) pre-coded mode, use the SOURCE ACCESS buttons (
or
) on the remote control to position the LED
light to the corresponding selection.
4.
Hold down the ENT button on the remote and enter the four digit preset code that matches your cable box as shown on pages 51-
52. Release the ENT button. The indicator light will flash 3 times if the code was accepted.
5.
Aim the remote at the cable box and press the POWER button. The remote will turn off your cable box when the correct four digit
preset code is entered. When this occurs, the remote control is programmed for your cable box. If the cable box does not turn off,
try a different four digit preset code.
6.
The remote will now control your Cable box.
NOTES:
1.
If your cable box cannot be operated after performing the
above procedures, your cable box code has not been
precoded into the remote.
2.
In the unlikely event that your cable box cannot be
operated after performing the above procedures, please
consult your cable box operating guide.
3.
The remote control will remember the codes you have
programmed until the batteries are removed from the
remote control. After replacing the batteries repeat the
entire programming procedure as stated above.
PRECODED CABLE BOX buttons
These buttons transmit the chosen precoded cable codes.
EXCLUSIVE TV buttons
These buttons are for operating the TV.
A/V NET
GUIDE
MY CABLE BOX CODE IS:
NOTE:
Refer to instruction manual of the Cable Box for operation of the buttons exclusively for the Cable Box.
THE REMOTE CONTROL
Summary of Contents for 32HLX61 - LCD Direct View TV
Page 104: ...QR64521 ...
