6
CAUTION
1. If liquid leaking from the battery gets into your eyes, do not
rub your eyes and wash them well with fresh clean water
such as tap water and contact a doctor immediately.
If left untreated, the liquid may cause eye-problems.
2. If liquid leaks onto your skin or clothes, wash well with
clean water such as tap water immediately.
There is a possibility that this can cause skin irritation.
3. If you
fi
nd rust, foul odor, overheating, discolor,
deformation, and/or other irregularities when using the
battery for the
fi
rst time, do not use and return it to your
supplier or vendor.
WARNING
If an electrically conductive foreign object enters the terminals
of the lithium ion battery, a short-circuit may occur resulting
in the risk of
fi
re. Please observe the following matters when
storing the battery.
◯
Do not place electrically conductive cuttings, nails,
steel wire, copper wire or other wire in the storage
case.
◯
Either install the battery in the power tool or store
by securely pressing into the battery cover until the
ventilation holes are concealed to prevent short-
circuits (See Fig. 1).
SPECIFICATIONS
POWER TOOL
Model
WH18DGL
Voltage
18 V
No-load speed
0 – 2400 min
-1
Capacity (Ordinary bolt)
M6 – M14
Tightening torque (Maximum)
145 N·m
Rechargeable battery
BSL1815S: Li-ion 18 V (1.3 Ah 5 cells)
BSL1825: Li-ion 18 V (2.5 Ah 5 cells)
Weight*
1.4 kg
1.4 kg
* Weight: According to EPTA-Procedure 01/2003
CHARGER
Model
UC18YKSL
Charging voltage
14,4 V – 18 V
Weight
0.35 kg
STANDARD ACCESSORIES
In addition to the main unit (1), the package contains the
accessories listed in the table below.
WH18DGL
1
Charger (UC18YKSL) ........................... 1
2
Battery (BSL1815S or BSL1825) .......... 2
3
Plastic case .......................................... 1
4
Battery cover ........................................ 1
Standard accessories are subject to change without notice.
OPTIONAL ACCESSORIES (sold separately)
◯
Battery
(BSL1815)
(BSL1825)
◯
Hook
(with screw)
Optional accessories are subject to change without notice.
APPLICATIONS
◯
Driving and removing of machine screws, wood screws,
tapping screws, etc
BATTERY REMOVAL/INSTALLATION
1. Battery removal
Hold the housing tightly and push the battery latches to
remove the battery (see
Fig. 2
).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2
).
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger’s power cord to a receptacle.
When the power cord is connected, the charger’s pilot
lamp will blink in red. (At 1-second intervals)
2. Insert the battery into the charger.
Firmly insert the battery into the charger as shown in
Fig. 3.
3. Charging
When inserting a battery in the charger, charging will
commence and the pilot lamp will light continuously in
red.
When the battery becomes fully recharged, the pilot lamp
will blink in red. (At 1-second intervals) (See
Table 1
)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown in
Table 1
, according to the condition of the charger or the
rechargeable battery.
000Book̲WH18DGL.indb 6
000Book̲WH18DGL.indb 6
2015/05/22 14:39:57
2015/05/22 14:39:57
