Introduction HS 200UTV-2/HS 250UTV-2
1-25
OPERATING NEW VEHICLE
How a new vehicle is handled and maintained
determines the life of vehicle.
A new vehicle just off the factory production
line has been, of course, tested, but the
various parts are not aligned to each other, so
the operator should pay more attention to
operating the vehicle for the first 50 hours at a
slower speed and avoid excessive work or
operation until the various parts become
“broken-in.” The manner to which you handle
the vehicle
during “breaking-in” period greatly
affects the life of your vehicle. Therefore, to
obtain the maximum performance and the
longest life of the vehicle, it is very important
to properly break-in your vehicle. For better
handling of a new vehicle, the following
precautions should be observed.
■
Do not operate the vehicle at full speed
for the first 50 hours.
Do not start quickly nor apply the brakes
suddenly.
In winter, operate the vehicle after fully
warming up the engine.
Do not run the engine at speeds faster
than prescribed.
On rough roads, slow down to suitable
speeds.
The above precautions are not limited to
new vehicles. However, they should be
especially observed for new vehicles.
■
Changing Lubricating Oil for New
Vehicles
The lubricating oil is especially important for
a new vehicle. Various parts need time to
wear and polish themselves to the correct
operating clearances. Small pieces of metal
grit may develop during the operation of the
vehicle; and this may wear out or damage
the parts. Therefore, change the lubricating
oil a little earlier than would ordinarily be
required. For further details of change
interval hours, see “MAINTENANCE”
section
STARTING
1. Fasten the seat belts during operation.
■
Seat Belt
WARNING
To avoid personal injury:
Seat belts reduce injury. Always wear
your seat belts. The lap-style seat belts
may not provide adequate protection
for
small
children.
Pay
special
attention
when
carrying
a
child
passenger.
CAUTION
：
To avoid personal injury:
Always use the seat belts when
operating and riding the vehicle.
Adjust the seat belts for proper fit and connect
the buckle. This seat belt is an auto-locking
retractable type.
Summary of Contents for HS 200UTV-2
Page 7: ...Introduction HS 200UTV 2 HS 250UTV 2 1 7 Seat belts Seat ...
Page 15: ...Introduction HS 200UTV 2 HS 250UTV 2 1 15 1 2 3 4 5 6 7 8 9 10 11 ...
Page 16: ...Introduction HS 200UTV 2 HS 250UTV 2 1 16 SERVICING OF VEHICLE ...
Page 57: ...Introduction HS 200UTV 2 HS 250UTV 2 1 57 3 Windlass 4 Motor Scan KF90121 ...
