Hisense MTZ60235FF, User'S Operation Manual

Page: 12 / 42

Hisense Refrigerator
5. Place refrigerator flatwise, remove
part
③ and then loose screws ④ .
Remove part ② and part ①
as the
picture .
4.Lever covers ① and loose
screws ② , remove the handle ③
as
show f igure Ⅰ , then place it at side
for use. Take the screw hole covers ④
down as show f igure Ⅱ , and install
them in the right side as show f igure
Ⅲ . Change handle to left, install it as
show f igure Ⅳ . Detach door stopper
⑤ and limit block ⑥ and then install
door stopper and limit block to right as
show
f
igure Ⅴ and Ⅵ
.
handle
① Handle covers ② Screws
③ Handle ④ Screw hole covers
⑤ Door stopper ⑥ Limit block
⑦ Self - tapping screws
6. Screw out lower hinge axis, change
it to the near hole site as the picture
below, and then screw up and mount
washer as the picture below.
③
④
①
②
① Left Lower hinge part ② Front foot fixed board
③ Adjustable bottom feet part ④ special flange self-tapping screw
8. Take off the part ①, place it at side
for use as show figure Ⅰ . Move the
freezer door to appropriate position,
adjust part
② and door, then fix part
② by screws as show f igure Ⅱ .
(Please hold upper door by hand when
installing). Fix
the part ③
as show
f igure Ⅱ ( which is in the plastic bag) .
Reverse part ① by 180°and install it
onto the left corner of the door as
show
f
igure Ⅲ
. Finally mount part ④
as show f igure Ⅳ. ( which was taken
down in step 2)
9.Finally install part ① and part ②
(both of which are taken down in step
2)
in the refrigerator body as the
picture below.
Ⅱ
④
Ⅰ
③ ② ①
Ⅳ
⑥
⑦
⑤
Ⅴ Ⅵ
Ⅲ
①
②
7.Just remount to the step 5,change
part
① to right and part ② to left and
then fix them with screws ④ . Finally
install part ③.
Note: washer may
stick to the door.
washer
hinge axis
Ⅱ
②
③
④
Ⅳ
Ⅲ
①
Ⅰ
１０