Hisense HUI6220XCUS, Operating Instructions Manual

Page: 14 / 24

Troubleshooting
Action Type of fault on the display
Clear the drain pump. See the chapter Care and maintenance instructions. If the
problem persists, call the Customer Care Center. Overfilling F10
See “Water remains in the dishwasher above the filters” in the table “Problem”
below. If the problem persists, call the Customer Care Center. Water outlet fault F11
Check that the water supply valve is on. If the problem persists, call the Customer
Care Center. Water inlet fault F12
Turn off the water supply valve and call the Customer Care Center. Inlet valve leakage F40
Clean the coarse and fine filters. If the problem persists, call the Customer Care
Center. Water level fault F52
Turn off the water supply valve and call the Customer Care Center. Overfilling F54
Call the Customer Care Center. Circulation fault F56
Press any button to clear the error message.
Action Possible causes Problem
Wait a moment then try again. You have pressed the buttons too soon
after opening the door. The buttons do not react when pressed.
Clean with a dry or slightly damp cloth. The buttons are dirty.
Open the door. The buttons only react
to use when the door is open. The door is closed.
Check that the baskets are correctly po-
sitioned horizontally. The baskets are not correctly positioned. Cannot close door.
Check that the dishes are not blocking
the baskets from sliding properly into
place.
Check the door lock. If it does not click
into place, open the door. Press and
hold the button for the Door Open option
for 15 seconds. Then wait 30 seconds.
Close the door. Check that the door lock
clicks into place. The door lock does not click into place
and lock.
14