Hisense HRWC30, User'S Operation Manual

Page: 10 / 17

Parts which heat up should not be
exposed. Wherever possible the back of
the product should be against a wall.
Before plugging in, ensure that the voltage
and frequency shown on the serial number
plate correspond to your domestic power
supply. Voltage can vary by
±
6% of the
rated voltage.
The appliance must be earthed.
Electrical connection
The power supply cable plug is provided
with a contact for this purpose. The power
socket must have an earth connection in
line with electrical safety regulations.
The manufacturer declines all responsibility
if the above safety precautions are not
observed.
Cleaning the interior
Before using the appliance for the first
time, wash the interior and all internal
accessories with lukewarm water and
some neutral soap so as to remove the
typical smell of a brand-new product, and
then dry naturally and thoroughly.
Do not use detergents or abrasive
powders, as these will damage the
finish.
This appliance does not contain gasses which
could damage the ozone layer, in either its
Environment Protection
Use
refrigerant circuit or insulation materials. The
appliance shall not be discarded together with
the urban refuse and rubbish. The insulation
foam contains flammable gasses: the
appliance shall be disposed according to the
applicable regulations to obtain from your local
authorities. Avoid damaging the cooling unit,
especially at the rear near the heat exchanger.
The materials used on this appliance marked
by the symbol
are recyclable.
INSTALLING YOUR NEW APPLIANCE
Before using the appliance for the first
time , you should be informed of the
following tips.
Warning!
For proper installation , the appliance
must be placed on a level surface of
hard material that is the same height
as the rest of the flooring .This surface
should be strong enough to support a
fully loaded appliance.
Ventilation of appliance
In order to improve efficiency
of the cooling system and
save energy , it is necessary to
maintain good ventilation around the
appliance for the dissipation of heat.
For this reason , sufficient clear space
should be available around the product.
Suggest:
It is advisable for there to be
50mm of space from the back to the
wall,100mm from its top,50mm from
its side to the wall.
As shown in follow diagrams.
Note:
Avoid locating the appliance in damp
areas .Too much moisture in the air will
cause frost to form quickly on the
evaporator.
Keep the appliance out of direct
sunlight , rain or frost . Stand the product
away from heat sources such as stoves,
fires or heaters.
8