Step-by-step installation guide
1.Beneath flat bottom cabinet
C. DETERMING TOP LI
NE OF REAR WALL TEMPLATE
LOCATION UNDER YOUR CABINET
F.CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
CAUTION -IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE-LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
Trim the rear wall template along the dotted line.
A
C
B
REAR WALL TEMPLATE
Front
Rear
TOP LINE OF REAR WALL TEMPLATE
TOP LINE OF REAR WALL TEMPLATE
F.CUT OUT FOR
HORIZONTAL
OUTSIDE
EXHAUST
CAUTION -IF EXHAUST ADAPTOR I
S POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREA
SE-LADEN AIR WILL
DISCHARGE INTO HOUS
E STRUCTURE
CUT HOLE THROUGH REAR WALL
FOR EXHAUST ADAPTOR
Trim the rear wall template along the dotted line.
A
C
B
REAR WALL TEMPLATE
F.CUT OUT FOR HORIZONTAL
OUTSIDE EXHAUST
CAUTION -IF EXHAUST ADAPTOR IS POSITIONED OUTSIDE
RECOMMENDED DIMENSION, GREASE-LADEN AIR WILL
DISCHARGE INTO HOUSE STRUCTURE
CUT HOLE THROUGH REAR WALL FOR EXHAUST ADAPTOR
9
TOP LINE OF REAR WALL TEMPLATE
Must align with cabinet bottom
At least 30”
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF
THE CENTER LINE.
MARK THE LOCATION FOR 2 ADDTIONAL,EVENLY
SPACED TOGGLE BOLTS IN THE MOUNTING PLATE
AREA.
Locate and mark holes to align with holes in the
mounting plate.
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaust
cutout .Do not use this temlate for vertical or
recirculation exhaust.
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
4. R
eturn to and proceed with the installation
instructions.
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaust
cutout .Do not use this temlate for vertical or
recirculation exhaust.
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
4. R
eturn to and proceed with the installation
instructions.
The bottom of the cabinet have three types:
NOTE: IT IS VERY IMPORTANT TO
READ AND FOLLLOW THE DIRECTIONS
IN THE INSTALLIONS INSTRUCTIONS
BEFORE PROCEEDING WITH THIS
REAR WALL TEMPLATE.
This template is for locating the horizontal exhaust
cutout .Do not use this temlate for vertical or
recirculation exhaust.
1.Tape the template to the rear wall.
2. Use a saber or keyhole saw to cut out the
shaded area F.through the rear wall.
3. Remove the template from the rear wall.
4. Return to and proceed with the installation
IMPORTANT:
LOCATE AT LEAST ONE STUD ON EITHER SIDE OF THE CENTER LINE.
MARK THE LOCATION FOR 2 ADDTIONAL,EVENLY SPACED TOGGLE BOLTS IN THE
MOUNTING PLATE AREA.
Locate and mark holes to align with holes in the
mounting plate.
