Hisense FV341N4EC1, User'S Operation Manual, Page: 9 / 20

Hisense Refrigerator
9
Note: Please hold the door by hand
during step 4 to prevent door dropping.
5. Remove the door and place it on a
smooth surface with its panel upwards.
Lever
part
①
and part
④
,then
screws
②
, as shown in the picture.
Change handle
③
to the left side, then
install screws
②
, part
①
and part
④
in
turn. screws
⑦
, detach part
⑥
and part
⑤
, turn part
⑥
over and then
install part
⑤
and part
⑥
to the right side
with screws
⑦.
loosen
Loosen
6. remove
part
③
and then loose screws
④ .
Remove part
②
and part
①.
Tilt the refrigerator back,
Special flange
self-tapping screws
Earth wire
①
②
③
Upper hinge part
1 2
3
②
Special self-tapping screws
③
Handle
①
Handle covers
④
Screw hole covers
⑤
Door holder
⑥
Stop block
⑦
Self-tapping screws
1
2 3 4
washer
Note: washer may
stick to the door.
②
Front foot fixed board
④
Self
-
tapping screws
③
Adjustable bottom feet part
①
Lower hinge part （ left ）
Note 2
:
Install the handle cover as
the following figure shows : locate
the buckle first, and then close the
cover from the inside until you hear
aclicking sound.
Note:
Please note the following
Note 1 :Remove the handle cover as
the following figure shows :bend the
upper and lower wings outwards and
pull the upper buckle away from the
handle, then slide the handle cover
off the handle.
buckle
buckle
7. Screw out lower hinge, change it to
the near hole site, and then screw up
and mount washer.
8.Just remount to the step 6,change
part
①
to right and part
②
to left and then
fix them with screws
④ .
Finally install
part
③.
Lower hinge part
（
right
）