Hisense DH-35K1SJE5, Use & Care Manual

Page: 10 / 21

Before calling for service, try the suggestions below to see whether you can solve your problem without outside help.
Dehumidifier will not run
Is the dehumidifier turned on
?
Turn on the dehumidifier
.
Is the power cord plugged into a grounded three-prong outlet?
Has a household fuse blown or has a circuit breaker tripped?
continues, call an electrician. See “Electrical Requirements.”
■ Is the bucket installed properly?
■
Does the bucket need to be emptied?
■ Is the water level float in place?
Remove the bucket
.
Make sure the float is snapped
■
■ Is the control set to Continuous?
■
■
■
Plug into a grounded three-prong outlet. See Electrical Requirements.
Replace the fuse or reset the circuit breaker. If the problem
■
Reinstall the bucket so that it fits all the way into the dehumidifier.
Empty the bucket
.
in place
.
Reinstall the bucket
.
the compressor will cycle back on
.
will run continuously
.
If the humidity level is low, little or
Clean the filter
.
Air coming from dehumidifier is warm
■
operating conditions
.
Dehumidifier displays trouble code
■
displays E1
,
E2
...
If the dehumidifier displays trouble code, the unit will still
work. But please contact the customer service.
TROUBLESHOOTING
Dehumidifier runs but does not dehumidify
All models have an automatic de-icer that will shut off
The filter is dirty or obstructed by debris
.
Ice forms on coils
■
the correct operating temperature.
All models have an automatic de-icer that will shut off the
the compressor and allow the fan to run.
This reduces the ice build-up on the coils
.
The compressor will cycle back on when the de-icer senses
the compressor and allow the fan to run.
When the de-icer senses the correct operating temperature,
If you have selected Continuous Run
,
the dehumidifier
no water may be collected.
Dehumidifier will put out warm air under normal
Electrical Shock Hazard
Plug into a grounded three-prong outlet
.
Do not remove ground prong
.
Do not use an adapter
.
Do not use an extension cord
.
Failure to follow these instructions can result in death
,
fire or electric shock
.
WARNING
10