Installation Instructions
UM19H User Manual, 99155C, November 2022
9
port on the monitor then retighten the retaining clip. Connect the other end into a nearby outlet.
HAZ
LOC
NOTE: If the retaining clip screw is not tightened, the product will not
comply with Class I, II, III, Division 2 Hazardous Location requirements.
DC power input models accept 9�6 to 36�6 VDC, 2�5 to 0�65 A, Class 2 or SELV/LPS�
1�
With main power disconnected, hook up incoming power
wires to the DC input terminal blocks according to the
label markings. Securely tighten terminal block screws.
2�
Plug the connector into the unit and secure by tightening
the two side screws�
HAZ
LOC
NOTE: If steps 1 and 2 are not performed, the
product will not comply with Class I, II, III,
Division 2 Hazardous Location requirements.
Connect and Set Up Touch Screen
Applies to touch screen monitors only� Instructions below apply to Windows systems�
Contact Hope Industrial Systems if you require a CD-ROM with documentation and touch screen
drivers. For a full list of downloadable drivers, please check the following address:
https://www�HopeIndustrial�com/support/drivers/
IMPORTANT!
If you will be using a USB connection,
install the touch screen driver first,
and then
connect the USB cable. If you will be using a Serial connection,
connect the Serial
cable first,
and then install the touch screen driver�
All touch screen models include both USB and Serial (RS-232) ports for touch screen operation,
but only one of these should be connected to the computer� When both ports are available on the
computer, USB is preferred�
Installing the Driver: USB Connections
1�
Do not plug the USB connection into the computer until the driver installation is