Installation / Setup Manual TRS 05 / PATB3
© Hirschmann Rev. -03/09/2006
190203_-
OPERATION
2.2 RECEIVER
Upon switching on crane ignition switch, the system starts with an automatic test of the receiver board,
LEDs and electronic components. The red power LED should be on and the green LEDs that sensors
have been linked to should also be on.
If an alarm condition exists investigate and clear the condition before operation and using the system.
During the normal operation of the system, the POWER and SENSOR ON LINE (if linked to a sensor)
LEDs should be on.
POWER LED
The POWER LED shows that the receiver is getting power from the crane. The receiver is on any time
the crane is operating and supplying power to the system.
SENSOR ON LINE LED
The SENSOR ON LINE LED indicates the status of communication of the transmitter(s). During
normal operation of the system, the LED will be on. The LED will flash if communication or
transmission between the sensor transmitter and the receiver is interrupted or lost. The system should
not be operated if the SENSOR ON LINE LED is flashing. If the LED is off no sensor is linked to this
channel.
LOW BATTERY LED
The low battery indicator (yellow LED) will light indicating that you have a limited time to operate
before the sensor battery life ends. When a low battery condition occurs, the follow 2 conditions will
exist:
1. The yellow LED will come on the TRS 05 for the sensor.
2. The signal for that sensor will cycle between input signal and max signal, which causes a
system fault and alarm for 25 seconds. The intent is to warn the operator that something is not
correct with the system. If the receiver is powered off/on and the low battery condition exists,
the signal will again cycle for another 25 seconds.
When the battery level is to the point that it is too low to operate, the system will display a loss of
communication and alarm. Use any off-the-shelf alkaline C-cells; Duracell, Eveready, etc. After
replacing the transmitter batteries, the receiver should clear the low battery indication.
ALARM LED
This LED will light simultaneously with the engaging of the lock out solenoids (if installed).
Summary of Contents for PAT TRS 05 / PATB3
Page 2: ......
