Hirschmann MS30, Power MICE, MACH 4000, OCTOPUS, User Manual

Page: 32 / 196

Entering the IP parameters
32
2.2 Entering the IP parameters via CLI
Layer 2 Enhanced with Layer 2 Professional
Release 1.0 10/05
2.2 Entering the IP parameters
via CLI
If you do not configure the system via BOOTP/DHCP, DHCPOption 82,
Hidiscovery protocol or the ACA AutoConfiguration Adapter, then perform
the configuration via the V.24 interface using the Command Line Interface:
Fig. 9: Flow chart for entering IP addresses
If there is no terminal or PC with terminal emulation available in the vicinity of
the installation location, the IP parameters can also be entered in your wor-
king environment prior to ultimate installation.
V
Set up a connection with the Switch in accordance with “Opening the
Command Line Interface” on page 19.
Entering IP addresses
Connect the PC with terminal
program started to the RJ11 socket
Command Line Interface
starts after key press
Log in and change to the
Privileged EXEC Mode
Switch off DHCP,
enter and save IP parameters
End of entering IP addresses