15
FH63 Series
●
0.5mm Pitch, 2.8mm high, Single Action Lock at bottom contact point, FPC/FFC/Shield FFC connector
B
Connector operation and points to note
[Operation method]
[Cautions for PCB layout]
Depending on the routing of FPC to mate, a load may be applied to the connector, which could lead to failure.
In order to prevent failure, please consider the following concerning the mechanism design.
[Caution]
· When routing the FPC, please be careful that FPC is not pulled and routing is carried out with a margin.
· Please check that the reinforcing film is placed horizontal to the board surface. (Example 23)
· Please insure there is no load applied to the connector in the pulling, inserting or lateral direction.
A bent FPC, it could cause contact failure or damage/disconnection of FPC. Therefore, please take some
measure to fix FPC etc. (Example 24)(Example 25)
· Don't place any parts under the FPC that will interfere with FPC. (Example 26)
· As for the flexibility of FPC, please make adjustments with the FPC manufacturer.
· Please ensure the FPC has adequate insertion space when designing the layout so that it is not inserted
diagonally.
Additionally, ensure the insertion space is not too short for FPC. Please adopt adequate parts layout and
length for FPC.
· When you design the board/layout, please secure a space required for operations.
Lock lever
Lock lever
Reinforcing film
Reinforcing film
Reinforcing film
Lock lever
Lock lever
The state where a load
is applied to FPC
The state where a load
is applied to FPC
Mounting parts
interfering with FPC
NG
NG
OK
NG
(Example 25)
(Example 26)
(Example 23)
(Example 24)
Mar.1.2018 Copyright 2018 HIROSE ELECTRIC CO., LTD. All Rights Reserved.
