HIRED-HAND MFG., INC.
•
1733 County Road 68
•
Bremen, Alabama 35033
•
PHONE 256-287-1000
•
FAX 256-287-2000
Manual Part No. 4801-5323 Rev 6-08 Page 1 of 10
MEGA-FLOW CONE FAN
Fan & Cone Installation
1. Disconnect power source before installing or
servicing fan. Failure to disconnect power
source can result in property damage,
serious injury, or death.
2. When connected to an automatic controller,
FAN MAY START AT ANY TIME.
3. IMPORTANT! Before Operating Fan, Inspect
Fan For any Object That May Obstruct Blade
Rotation.
!
WARNING!
BEFORE INSTALLING
1. Inspect fan for damage in transit. Check for
loose, missing, or damaged parts.
2. If there are any missing parts or if there is
any shipping damage, do not attempt to
operate fan. Contact your Distributor.
MAINTENANCE
1.
Read WARNING statements before proceeding.
2.
Blades, motor, and wire guards should be cleaned
periodically to decrease vibration and ensure
maximum fan life. Remove dirt with a dry brush or
compressed air. DO NOT SPRAY MOTOR WITH
WATER OR CLEANING FLUIDS.
3.
Fan performance may be greatly reduced by
damaged or dirty shutter. Clean and inspect shutter
periodically to ensure maximum fan performance.
When this fan is used in a life support ventilation
system where failure could result in loss or injury,
the user should provide adequate backup
ventilation, or accept the risk of such loss or injury.
IMPORTANT!
WARRANTY
Your Mega-Flow fan has been manufactured with the finest
materials and components available and is backed by a one year
warranty against electrical and mechanical defects in material and
workmanship. If this fan fails to operate during this period, return it
prepaid to place of purchase for repair or replacement without
charge at the manufacturer's option.
This warranty gives you specific legal rights and you may have other
rights that vary from state to state.
Mega-Flow Fan & Cone
1.
Fan should be securely mounted to wall. Refer to
mounting instructions on sheet 3 of this manual.
2. The cone and wire guard must always be installed for
your protection.
National safety codes require that guards be installed
if within 7 feet (2.1 m) of floor or within reach of
personnel or livestock.
3. If thermostat is used, connect fan power cord to
controller.
INSTALLATION
Summary of Contents for MEGA-FLOW CONE FAN
Page 10: ......
