- 5 -
STOVES & CHIMNEYS
NOTICE FOR SAFETY
CAUTION
In case of storing this heater, be sure that you store
it in the dry places indoor instead of hot and humid
environment.
(Otherwise, it gets rusty or goes into trouble)
You must take out the plug from the outlet, if there
is a fl ash of lightening or thunder or you don’t use
it for a long time.
(Otherwise, it is exposed to the danger of electrical
shock, short circuit or a fi re.)
If the supply cord is damaged, it must be replaced
by the manufacturer or its service agent or simi-
larly qualifi ed person in order to avoid a hazard.
Call your local after sales service agent in case the
power cord is damaged.
(Otherwise, it is exposed to the danger of electrical
shock, short circuit or a fi re.)
Do not put this heater on unstable surface of
ground such as inclined or bumpy.
(The heater may not work properly.)
Do not shower water to the heater directly, nor use
benzene, thinner, alcohol for cleaning.
(Otherwise, it is exposed to the danger of electrical
shock, short circuit or a fi re.)
Do not put an excessive physical shock to the re-
mote controller, nor disassemble it arbitrarily.
(it arbitrarily.)
Do not operate this heater in the place where it
gets wet by the humid such as bathroom.
(It may cause an electrical short circuit or an electrical
shock accident)
TIPS BEFORE INSTALLATION ...
1. Make sure the safety in the place where you wish to use
this heater.
The ground surface and surrounding should be plain
and non-fl ammable, and solid.
You need to have suffi
cient space surrounding the
heater at least 15cm from the wall and the left & right
side, at least 1 m distance from the ceiling and the
front side without any obstacle.
You need to use exhaust duct in case of operating in
small spaces.
(Recommended Duct specifi cation:
75mm
⌀
(Diameter) x 5meter long-aluminum duct)
(Be sure there must not be rain drops into the
exhaust duct end.)
(You must ventilate frequently with fresh air by
opening window or fan.)
You must put an extinguisher beside the heater.
There must not be direct sun light, excessive heat
near the heater.
After you fi x the installation, lock the caster for
avoiding unexpected movement.
Do not use this heater near fabric curtain, carpet or
plastic or vinyl curtain which may cover the heater in
case of falling down by the wind or by any physical
force, which may cause a fi re.
The heater must not be located immediately below a
socket-outlet.
Positioned so that the plug is accessible.
2. You must use Diesel or kerosene as fuel.
If you use other fuel, it may cause an excessive soot or
trouble of malfunction.
In case of refueling make sure the heater is turned
OFF.
To be made by the manufacturer or his service agent
who should be contacted if there is an oil leakage.
Regulations concerning the disposal of oil when
scrapping the appliance have to be followed.
3. The proper electricity is 220/230V, 50Hz. It will be
applied and adjusted as per customer’s request. You
must supply power as per its requirement only once it
is adjusted.