Hioki SW9001, Instruction Manual

Page: 51 / 170

47
6
Initialization
6.1 Initialization Settings
The device is in the initial state at the time of shipment and at the time of initialization using
commands. However, communications settings will not be initialized if the initialization is triggered
by command.
Settings that are backed up can be stored so that they persist even when the power is turned off by
executing the
:SYSTem:BACKup
command.
See: “Backing up settings” (p. 105)
Communications settings are backed up even if the
:SYSTem:BACKup
command is not executed.

: Yes, –: No
Item Initialization description Backup
Channel relay All relays open –
Bus relay All relays open –
EXT. I/O CLOSE output signal OFF –
Connection method
SW9001: 2-wire
SW9002: 4-terminal pair

Shield switching
SW9001:
TERMINAL 1
, LOW terminal
SW9002: TERMINAL 3 , sense shield terminal

Channel delay settings 0.0 s

Scan list None

Scan operation trigger source STEP

Query forwarding timeout 10 s

EXT. I/O filter function OFF, 0.05 s

Pulse width of CLOSE output
signal
0.005 s

Communication settings (USB) (No setting item) –
Communication settings
(RS-232C)
9600 bps

Communication settings (LAN)
User setting mode (setting switch: USER )

IP address: 192.168.0.254
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0 (None)
Communication command port number: 23
Fixed setting mode (setting switch: DFLT )
–
IP address: 192.168.0.254
Subnet mask: 255.255.255.0
Default gateway: 0.0.0.0 (None)
Communication command port number: 23
6 Initialization
6
Initialization
HIOKI SW1001A961-04