Hioki SW9001, Instruction Manual

Page: 131 / 170

127
List of Device Error Numbers
10.2 List of Device Error Numbers
This section provides a list of device error numbers.
You can acquire the number of any error that occurs as well as a description of the error using the
:SYSTem:ERRor?
query.
See: "Query and clear error information" (p. 100)
Error No. Error description Details Solution Reference
−100 Command error Illegal command string Check whether there is no error
in the command string.
p. 71
−200 Execution error Unable to execute
command with the
specified conditions
It may not be possible to
execute the command in
question under the present
conditions.
p. 80
−220 Parameter error Out-of-range or illegal
parameter
Check the command parameter
range or string.
p. 90
−222 Bad Slot/Ch Illegal slot or channel
specification
Check the specification method
and parameter string.
p. 98
−313 Backup lost Corrupt device hardware
information
Repair is necessary. – −315 Setting backup lost Corrupt settings backup
data
−330 Self-test failed Error during self-test
−360 Communication error Communications error
Check the communications
settings (forward speed,
etc.). Check whether the
communications lines are being
affected by noise.
p. 68
−361 Rs232c parity error RS-232C parity error
−362 Rs232c framing error RS-232C framing error
−363 Rs232c overrun RS-232C overrun error
−365 Time out error Timeout
−370 Module backup
failed
Corrupt module information Repair is necessary.
–
−371 Comm transfer
Timeout
Communications
forwarding function timeout
Check the communications
settings on the connected
instrument. Check the
command being sent for errors.
p. 69
−372 Comm transfer
overrun
Communications
forwarding function receive
buffer full
−373 Comm Transfer
RS232C error
Communications
forwarding function
RS-232C communications
error
−400 Query error Full send buffer when
sending a query
Be sure to receive the response
when you send a query.
p. 76
10
Maintenance and Service
HIOKI SW1001A961-04