Hioki SM7860-01, Instruction Manual

Page: 34 / 54

3.6 Message List
30
Voltage monitor
VMA?
Circuit A power supply voltage monitor value query [Format] VMA?
[Response] d1: NR2 format
VMB?
Circuit B power supply voltage monitor value query [Format] VMB?
[Response] d1: NR2 format
LCD display mode
LCD
LCD display mode setting
d1 (Display mode: 0 to 1)
0: OFF (Display off)
1: ON (Display on)
[Format] LCD d1
d1: NR1 format
LCD?
LCD display mode query
The contents of responses are the same as the settings.
[Format] LCD?
[Response] d1: NR1 format
PAG
LCD display page specification
d1 (Page number: 0 to 1)
0: Output voltage setting, monitor voltage value, channel-spe-
cific output setting state
1: Alarm setting, GP-IB address
[Format] PAG d1
d1: NR1 format
Error information
ERR?
Error information query
d1 (Error information: 0 to 127)
Note: Error information is cleared when the response is output.
[Format] ERR?
[Response] d1: NR1 format
Others
*
RST
Device initialization
Initializes all settings to their factory values.
Device operation will be stopped.
[Format]
*
RST
*
IDN?
Hardware ID query
Returns the device’s hardware ID as the response.
d1 (HIOKI, SM7860-XX, 0, 01.00)
Note: The SM7860-2X is shown as "SM7860-0X."
[Format]
*
IDN?
[Response] d1: String
*
SAV
Save environmental data
(output voltage setting and alarm setting)
d1 (Environmental data no.: 0 to 3)
[Format]
*
SAV d1
d1: NR1 format
*
RCL
Recall environmental data
(output voltage setting and alarm setting)
d1 (Environmental data no.: 0 to 3)
[Format]
*
RCL d1
d1: NR1 format
*
CLS
Clear status register [Format]
*
CLS
*
SRE
Sets the service request enable register.
d1 (0 to 255)
[Format]
*
SRE d1
d1: NR1 format
*
SRE?
Service request enable register query
d1 (0 to 63, 128 to 191)
Note: Bit 6 is not set by
*
SRE .
[Format]
*
SRE?
[Response] d1: NR1 format
*
STB?
Status byte register query
d1 (0 to 255)
[Format]
*
STB?
[Response] d1: NR1 format
*
ESE Sets the standard event status enable register.
d1 (0 to 255)
[Format]
*
ESE d1
d1: NR1 format
*
ESE? Standard event status enable register query
The contents of responses are the same as the settings.
[Format]
*
ESE?
[Response] d1: NR1 format
*
ESR?
Standard event status register query
d1 (0 to 255)
[Format]
*
ESR?
[Response] d1: NR1 format
Command Description Formats