Hioki RM2610, Instruction Manual

Page: 28 / 138

24
Mounting the RM9004 Test Fixture on the RM9003 Press Unit
2.2 Mounting the RM9004 Test Fixture on the
RM9003 Press Unit
IMPORTANT
Exercise care not to lose the test fixture case’s mounting screws, which you will need in order to store the
RM9004 Test Fixture during transport.
Preparations
Remove the four mounting screws from the top of the
RM9004 Test Fixture and remove the test fixture from the
test fixture case.
2
1
Test fixture lock lever
3
Assembly
1
Place the RM9003 Press Unit’s up/down
lever in the raised position.
2
Orienting the connector side of the
RM9004 Test Fixture so that it’s facing
the rear, slide the test fixture into position
along the RM9003 Press Unit’s test fixture
insertion rails.
Push the test fixture toward the rear until it won’t
go any further.
3
Pull the test fixture lock lever toward you
and downward and then let go.
The RM9004 Test Fixture will lock in place.
4
4
Connect the grounding cable on the rear
of the RM9003 Press Unit to the ground
terminal on the RM9004 Test Fixture.