Hioki MR8904, Instruction Manual

Page: 58 / 72

6.3 Checking Logic Channel Allocation
54
You can check logic channel allocation as configured with the MR8904 CAN Editor.
1
Display [Setting Display]

[Channel]

[Logic] on the MR8875.
2
Select the channel to which CAN definitions were allocated.
The following information will be displayed:
6.3 Checking Logic Channel Allocation
1
2
Port
Number of the port with which data will be received
ID Message ID to receive
Signal
Name associated with received messages
Label
Identifying label associated with received messages
Bit Assign
Indicates how many bits from the LSB* of the received message to
measure. When an ID trigger has been allocated, displays “ID trigger.”
*: See "How to count the bit position" (p.28).
Start Send Frame
Selects the timing at which to send messages.
See:
"6.4 Setting the Transmission Timing" (p.55)
The display position can be selected as follows:
• When the logic recording width is [Normal] , Pos1 / Pos2.
• When the logic recording width is [Wide] , Pos1.