Hioki MR8904, Instruction Manual

Page: 59 / 72

6.4 Setting the Transmission Timing
55
This section describes how to set when to start transmission as configured with the MR8904 CAN Editor.
1
Display [Setting Display]

[Channel]

[Analog]

[Detail] on the MR8875. If
using a logic channel, display [Setting Display]

[Channel]

[Logic] .
2
Select the channel to which CAN definitions were allocated.
3
Select the transmission timing with the [Start Send Frame] setting.
(Continues on next page.)
6.4 Setting the Transmission Timing
Setting Contents (

Default setting)
Auto*
Frame transmission starts when measurement starts and stops when
measurement stops.
Manual
Transmission starts and stops when a button on the Waveform screen
is touched during measurement. Frames cannot be sent when mea-
surement is not in progress, manually or otherwise.
1
2
1
3