Hioki MR8904, Instruction Manual

Page: 56 / 72

6.2 Checking Analog Channel Allocation
52
You can check analog channel allocation as configured with the MR8904 CAN Editor.
1
Display [Setting Display]

[Channel]

[Analog] on the MR8875.
2
Select the analog channel to which CAN definitions were allocated.
3
Select [Detail] .
The following information will be displayed:
6.2 Checking Analog Channel Allocation
1
2
3
Port
Number of the port with which data will be received
ID Message ID to receive
Signal
Name associated with received messages
Label
Identifying label associated with received messages
Bit Length Bit length of received messages
Units
Unit for received messages
Start Send Frame
Selects the timing at which to send messages.
See:
"6.4 Setting the Transmission Timing" (p.55)