Hioki MR8740, Instruction Manual

Page: 138 / 424

6.4 Performing Waveform X-Y Synthesis
126
Procedure
To open the screen: Right-click and select [DISP]
→
Waveform screen
→
Right-click and select [CH.SET]
→
X-Y settings window
4
Set the waveform color in the graph display. Select
Move the flashing cursor to the graph color item to set,
and click it.
Set the waveform display color.
You can also select the same color as for another channel.
5
Select the channels for X-Y synthesis.
Move the flashing cursor to the items for the X (time
axis) and Y (voltage axis) and assign a channel.
The same channel can also be assigned multiple times.
Off Waveform display is off. If [Save Channel] is
set to [Disp Ch] in the Auto Save settings, the
data will not be saved.
See: "Select the channels to save." (p. 102)
On The waveform is displayed. Set the display col-
or by clicking
[ ↑ ] or [ ↓ ] .
4 5
Synthesis for A/B section of a waveform
Perform the following steps.
1. Right-click and select
[STATUS] to bring up the Status screen, and select
the [Status] sheet.
2. Select 1, 2, 4, 8 or 16 screens as [Format] .
3. Right-click and select [DISP] to display the waveform.
4. Use the A/B cursors to specify the range for synthesis. See the following
pages. (p.118), (p.122)
5. Right-click and select [STATUS] to bring up the Status screen, and select
the [Status] sheet.
6. Select [X-Y Single] or [X-Y Quad] for [Format] .
To move pen on synthesized waveform
You can move the pen over the entire waveform by rotating the mouse wheel
button.(Click the
[WAVE] icon while AB CSR is displayed.)
The time at the pen position is shown at the top right of the screen.