Hioki LR8431, Instruction Manual

Page: 84 / 204

4.4 Starting and Stopping Recording by Timer
76
Make these settings to record at a specific time. Recording can be set to
repeat at specific intervals between the set start and stop times.
Before setting, confirm that the Memory HiLogger clock is set to the correct
time. If not, reset the clock on the [System] screen (p. 124).
4.4 Starting and Stopping Recording by Timer
Select the [Setting] Screen.
Move to a setting item.
Apply
Open the setting options
for the item to be set.
Select from the listed
options.
1
2
Change 1’s digit Change 10’s digit
1
Set the
[Timer]
setting to
[On]
.
2
Enable (set to [On]) the desired timer set-
ting items.
Setting options:
3
Set the year, month, day, hour, minute and
second for the start or stop time.
To enter the current time as the start or stop time,
select the clock mark (
) and press the
ENTER
key.
4
For the [Interval] settings, set the amount of
time (days, hours, minutes and seconds)
between recording repetitions.
5
Press START.
[Wait Timer]
will be displayed at the bottom of the
waveform screen.
Start Set the recording start time.
Stop Set the recording stop time.
Interval Set the recording repetition interval.
This setting is enabled on when [Repeat]
is set to [On].
Stop
measurement
Start

measurement
Recording
Recording time
Recording Interval
When recording times are
specified, recording operation
depends on the repetition and
recording time settings(p. 78).