Hioki 8860-50, Instruction Manual

Page: 243 / 490

8.15 Inserting and Searching for Event Marks on a Waveform
231
8
Chapter 8 W
av
eform Screen Monitoring
and Analy
sis
You can search for any marks (event marks) inserted on waveforms during and
after measurement.
* Event marks inserted on a Recorder waveform
You can insert up to 1,000 event marks of 16 types, which can be edited and
assigned comments. A list of event marks can be printed (p. 348).
An event mark is inserted on the waveform every time you press the START key
during measurement.
Event marks can also be inserted by signals at the external Start terminal input.
In addition, event marks can be inserted at locations searched with the Search
dialog.
• When using the Memory Division function in the Memory function, event
marks cannot be inserted.
In the REC&MEM function, event marks can be inserted on a Recorder wave-
form.
• To confirm the location of event marks, they can be searched for in the Event
Mark List.
See "8.15.2 Event Mark Searching" (p. 232)
• Event marks can be repositioned, added, deleted and edited after measure-
ment.
See "8.15.3 Event Mark Editing" (p. 233)
• Event marks cannot be inserted after pressing the STOP key once while mea-
suring (and “Push again to stop measurement” is displayed).
8.15 Inserting and Searching for Event Marks on
a Waveform
Supporting Function

(Only when Memory
division is disabled)




 
Event mark information list
(EVENT MARK dialog)
E E
Search
Event mark
8.15.1 Inserting Event Marks