Hioki 8860-50, Instruction Manual

Page: 103 / 490

4.2 Setting Measurement Configuration (Status Settings Screen)
91
4
Chapte
r 4
Me
asuremen
t Co
nfiguration Sett
ings
The following two setting methods are available:
• Using the operating keys
• Using the
TIME/DIV key (settable regardless of cursor position)
The data refresh rate is not allowed to exceed the maximum sampling rate of the
input module.
Example: Using an input module with maximum sampling rate of 1 MS/s (up to
1M samples per second). 1 MS/s = 1 µs/S (1 µs sampling period)
When the
[Sampling Speed] is set to [50 ns/S] , data is refreshed once each µs.
The maximum sampling rate of the input module being used can be verified on
the Config (Configuration) screen ("13.3.6 System Configuration List" (p. 374)).
Also, when sampling at different rates, if the recording time determined by the
specified recording length is shorter than the Timebase 2 sampling rate, no data
is sampled on Timebase 2.
Timebase 1
Timebase 2
Recording Length (Recording Duration)
Sampling Period
Timebase Setting: Using the TIME/DIV Key
To open the screen: Press the
SET
key

Select with the
SUB MENU
keys

Status Settings screen
See Screen Layout (p. 28), To set from the Waveform screen (p. 114)
Select slower
timebase
The value changes with each key press.
Select faster
timebase