Hioki 3197, Instruction Manual

Page: 61 / 200

53
4
After connecting the instrument to the lines to be measured and before
starting recording, verify the instrument settings.
Settings can be made in the following three ways.
Pre-Measurement and System
Settings
Chapter 4
Setting Screen Contents
(Pressing the SYSTEM key selects among setting screens)
Setting Contents Settings Screen Refer To
Basic measurement settings [MEASURE]
"4.2 Selecting the Measurement Method (SYS-
TEM Screen) [MEASURE]" (p. 57)
Recording method settings [REC&EVENT]
"4.3 Setting the Recording Method
[REC&EVENT]" (p. 63)
Event detection settings [REC&EVENT]
"4.4 Setting Event Detection [REC&EVENT]"
(p. 67)
Instrument system settings [SYSTEM]
"4.5 Changing Instrument System Settings
[SYSTEM]" (p. 72)
Advanced Settings Basic Setup
Begin measuring when finished making settings and connections.
Make only the minimum required set-
tings in preparation for recording
measurements. Make settings from the SYSTEM
screens. Press the SYSTEM key to
select among the setting screens.
"4.2 Selecting the Measurement
Method (SYSTEM Screen) [MEA-
SURE]" (p. 57)
"4.5 Changing Instrument System
Settings [SYSTEM]" (p. 72)
"4.1 Basic Setup (Typical Settings)"
(p. 54)
"5.2 Connecting to the Lines to be Measured" (p. 81)
"5.4 Starting and Stopping Recording" (p. 88)
Refer to "Appendix 8 List of Settings (Default Settings)" (p. A13).