TRACKS MOVEMENTS
To move the tracks it’s necessary that all the outriggers are raised from the
ground. It’s possible to move the tracks even if jib arm (last arm, see picture
below) is opened but in this case basket should be empty, therefore the
operator must be at the ground keeping the remote control on his hands.
Otherwise when jib arm is closed the tracks could be moved operating from the
basket.
To move the tracks (with all the outriggers raised from the ground) press the
tracks red joystick on the remote control. To open the jib arm press the jib
movement joystick. Jib should be closed to allow outriggers movements. Tracks
speed could be limited by an automatic speed control that prevent unsafe
translation conditions.
OUTRIGGERS MOVEMENTS
To move the outriggers it’s necessary that the
machine is perfectly closed and aligned (all the arms
and the jib closed). In this case the display shows
the MACHINE CLOSED AND ALIGNED icon (see the
picture below on the left). To move the outriggers
the remote control could be in the basket support or
the operator can keep it in his hands also standing
on the ground.
OUTRIGGERS UNBLOCKING
Outrigger to be moved need to be opened. To open each outrigger it’s
necessary to lift the mechanic block shown by picture lifting the handle and at
the same time rotating the outrigger manually. To move aerial part machine
must be stabilized.
AUTOMATIC STABILIZATION:
To stabilize the machine automatically the machine must be closed aligned
(all the arms and the jib closed and turret aligned).
TRANSLATION WITH JIB CLOSED
IS POSSIBLE FROM THE GROUND
OR FROM THE BASKET.
TRANSLATION WITH JIB OPENED
IS
POSSIBLE
ONLY
WHEN
OPERATOR AT THE GROUND
JIB ARM
OPENED
ALIGNMENT
ARROWS
PHOTOCELLS SYSTEM DETECTS
WHEN MACHINE IS CLOSE AND
ALIGNED
