Hinowa LightLift 15.70 3S, Technical Course Booklet

Page: 25 / 137

25
Once fulfilled the AUTO-STABILIZATION procedure
till the OK, all the outriggers touch the ground and
machine is levelled, then, placing the remote
control on its basket support the display will show
the “MACHINE STABILIZED” icon on position n.5
and aerial part movements will be allowed.
LL15.70 is able to stabilize on a surface up to 15° of inclination, in case of the
surface exceed that limit machine will not allow to start the stabilization
procedure and display will show the MAXIMUM TILT ANGLE EXCEEDED icon.
NOTE: During the intermediate steps of auto-stabilization and outriggers auto-
retraction, while two or three outriggers are touching the ground, the engine
automatically runs at minimum rpm to ensure smooth movements.
NOTE: If pedal option is active the
“MACHINE STABILIZED“ icon appears after
pedal have been pressed to enable the aerial part movements.
4.2.2 OUTRIGGERS AUTO-RETRACTION
To be able to automatically retract the outriggers the machine must be closed
and aligned, to automatically retract the outriggers it has to be kept pressed
remote control button n.1
“ OUTRIGGERS AUTOMATIC RETRACTION ”.
“MAXIMUM TILT ANGLE EXCEED”
ICON
“MACHINE
STABILIZED”
ICON
AUTOSTAB
WAIT
ST1 GND
ST2 NO GND
ST3 NO GND
ST4 NO GND
AUTS
STEP: 2
OK
AUTOSTAB
WAIT
ST1 NO GND
ST2 NO GND
ST3 NO GND
ST4 NO GND
AUTS
STEP: 1
AUTOSTAB
WAIT
ST1 GND
ST2 GND
ST3 GND
ST4 GND
AUTS
STEP: 49