Hiniker 2752, Operator'S Manual

Page: 22 / 31

20 Plow Assembly
17. Remove the plug mount plate kit from the
hardware bag in the parts box.
REF.
NO.
PART
NUMBER
DESCRIPTION QTY.
1
2
3
4
5
6
7
8
9
10
25011037
700-10904
951-003-014
950-004-076
392-010-010
950-004-033
36716025
367-001-011
25010278
36716002
Clamp
Machine Screw #6-32 x 1
Lock Nut #6-32 Nylon Insert
Machine Screw #10-24 x 1 1/2
Lock Nut #10-24 Nylon Insert
Machine Screw #6-32 x 1/2
Nylon Lanyard 8”
Cable Tie 14”
Plug Mount Plate
Dust Cap
1
1
5
2
2
4
1
4
1
2
Fasten the power cable connector to the
clamp by inserting the #6 x 1 inch machine
screw through the small hole in the con-
nector, then through the center hole of the
clamp. Secure the screw with a #6 lock nut.
Fasten the clamp to the mount plate with
the two #10 x 1-1/2 inch machine screws
and #10 lock nuts supplied.
Mount the 10-pin circular connector to the
mount plate with four #6 x 1/2 inch screws
and lock nuts such that the tab on the con-
nector will be up, as shown.
Assemble the mount plate and connector
covers to the vehicle grill with plastic ties.
18. Locate three blue connector splices in the
hardware bag in the plow’s parts box.
DWG NO. 4165
Using a blue splice, crimp the single brown
wire from the underhood harness into the
vehicle’s driver’s side parking light wire.
Using a blue splice, crimp the single yellow
wire from the underhood harness into the
vehicle’s driver’s side turn signal wire.
Using a blue splice, crimp the single green
wire from the underhood harness into the
vehicle’s curbside turn signal wire.
19. Select the proper headlight adapter for your
vehicle, specific instructions are included
with each kit.
The headlight adapter kit consists of two
identical adapters. Install the adapters ac-
cording to the instructions included with the
kit and connect to the 5-pin connectors of
the underhood wiring harness.
20. Secure all cables away from hot or moving
components with cable ties.
This completes the Electrical Installation.
21. At this point, the mount kit should be as-
sembled onto the truck.
Prongs from the truck mount kit should
be at a height that will slightly lift the plow
frame when attaching the plow. Prong re-
ceivers on the plow frame should be paral-
lel to the ground when attaching the plow.
Apply powered graphite on the truck prongs
to help the plow to slide on and off more
easily.
DWG NO. 3900