Page
Rev. 3
6
B. DIRECT KEY OPERATION
B.1 Power ON/OFF (Hardware)
Long press power switch to start normal operation mode, long press again will power
down.
B.2 VOL/SQL KEY
Short press VOL/SQL key to adjust volume level,press UP/DOWN key to select volume
level accordingly.Long press VOL/SQL key will flash squelch level,press UP/DOWN key to
select squelch level accordingly.
B.3 UP/DOWN
At the normal mode, they act as Channel Up/Down. When it press > 0.5 sec, the unit will
start to scrolls through the channels at 125ms intervals. It returns to normal mode when key
press is released
B.4 16/9 Channel
Summary of CH16/9 Key operation:
1 If current channel was not priority channel,press 16/9 key will directly jump to 16 channel
or 9 channel(short press to jump to priority CH16 at High Power and long press to jump to
priority CH9 at High Power)
Note: Accessing the priority channel will change the power setting to high power. The user
can change the power setting to low power by pressing Hi/Lo/LOCK key. If the priority
channel is limited by the cloning software for 1-W only, accessing priority channel will still
follow the low power limitation.
2 After the channel is tuned to the priority channel, the
“
P
”
icon is lit to indicate that the
priority CH16 or CH9 has been reached. UP and Down key functions normally
3 When the radio already tunes to the priority channel ,pressing 16/9 key will revert radio to
the previously used working channel depending on how it being press (see flow chart above).
16/9 Key also act ‘esc key’ to exit other modes
To reprogram a secondary priority channel
:
1.Tune to priority CH9. It is indicated by
“
P
”
icon. It is done by pressing
“
16/9
”
key for
more than 3 seconds.
2.Then, press and hold the
“
16/9
”
key for 3 seconds.
3 and Currently secondary priority channel number should start flashing
and the current secondary priority channel number should start flashing.
