HIMS Inc.
BookSense XT – User Manual
6) Press the OK or MENU button to begin formatting. “Now formatting XXXX” and in a while
‘successfully formatted XXXX” is announced.
If you want to cancel formatting the drive, press the LEFT or RIGHT button to select no.
9.11 Set Current Storage Device
To set the current storage device, follow these steps:
1) Press the MENU button. Press the UP or DOWN button to move to the “Global options,
pull down.”
2) Press the RIGHT, OK, or MENU button. BookSense says “Alarm Settings, pull down.”
3) Press the UP or DOWN button, move to ‘set current storage device, dialog.” Press the
RIGHT, OK or MENU button. BookSense announces, ‘storage device settings dialog,
current storage device: Flash disk, combo box.” You can change this to the external
memory card; SD card, or USB stick if they are connected to the device by pressing the
LEFT or RIGHT button.
4) Press the OK button on the option that you want to use. The contents is stored in the
folder that can be used on the BookSense XT. Please refer to section 2.1: Folders used
in the BookSense XT.
Note: You can only change to available drives. The drives you can change to are Flash disk,
SD card, or USB. Press the OK or MENU button to apply the setting. If the external memory
card is not connected, you can only check Flash disk.
Note: In file list, you can also press number 0 button more than 2 seconds to switch between
the current storage devices. This allows you to switch on the fly without using the menu.
87
