hilton HSM 1003, Operating Manual

Page: 21 / 26

Attention!
1. Read the instructions before using the hair clipper and save this
Instruction Manual.
2. Remove all packing materials from the unit and check for damage. Do
not use damaged parts of the device.
Watch out - you can get hurt!
REGULATION OF THE BLADES
1. Before leaving the factory machines with knives carefully check that
they are lubricated and adjusted.
2. If the blades have been replaced or removed for cleaning, they should
be re-adjusted. To re-adjust the blades, just insert each point of the upper
and lower blades in a position where their teeth are looking up. The ends
of the upper teeth of the blade must be separated from the teeth of the
lower knife for a distance of approximately 1.2 mm. Compare the position
of knives on your hair clipper blades with the position in the diagram.
3. If the adjustment is carried knives properly, apply a few drops of oil
knives, switch machine for a few seconds, turn off and unplug. Loosen the
screws and make the adjustment. Tighten the screws after adjustment
carried knives.
BUTTER KNIFE 1. To keep your hair clipper in the
best working condition, knives should be
lubricated after a few haircuts.
2. Do not use hair oil, grease, butter mixture of
kerosene or any solvent, as they evaporate,
leaving behind a layer of thick oil, which can slow
down the blades.
POWER REGULATION: lead screw
1. The lead screw allows you to adjust the power. Before leaving the
factory machines have been adjusted power. But if the power in your
house is low, you can re-adjust the power.
2. Use a screwdriver or small coin to turn the spindle clockwise until the
handle touches the ring, you will hear a sound. Then slowly turn the
spindle clockwise until the sound stops. You set the maximum power of
the device.
eng